Office 17B, Sino Pak Plaza, College Road, Rawalpindi +92 321 2750276 ceo@nztech.com.pk

Electronics & Component-Level Repair

PCB & Circuit Board Repair

Component-level diagnosis and repair of single-layer, double-layer and multi-layer printed circuit boards from any equipment.

Book This Repair
Technician performing component-level PCB circuit board repair with a soldering iron and tweezers

Boards and faults we work on

  • Single, double and multi-layer PCBs
  • Burnt or lifted tracks and pads
  • Damaged vias and through-holes
  • Short circuits and earth faults
  • Boards damaged by voltage spikes or reverse polarity

Common Faults We See

  • Dead board — no power anywhere
  • Intermittent faults that come and go
  • Burnt smell or visible scorch marks
  • Equipment tripping the breaker on switch-on
  • One function of the equipment stopped working

How the Repair Is Handled

Boards are tested section by section — power stage first, then control and signal paths — and faulty components are replaced at component level rather than swapping the whole board.

  1. Book the job online and note your job number.
  2. Drop the equipment at our Rawalpindi workshop, or courier it to us.
  3. We diagnose the fault and share a quotation — confirmed at diagnosis, with no work done before your approval.
  4. After repair, the equipment is tested and quality-checked before you collect it or we courier it back.

You can follow every stage afterwards on the repair tracking page with your job number and phone number.

Book This Repair

Send in your equipment for diagnosis. The quotation is shared with you before any repair work starts — nothing is repaired without your approval.

Book a Repair Track an Existing Job

Prefer to talk first? Call +92 321 2750276 or message us on WhatsApp.

PCB & Circuit Board Repair — Frequently Asked Questions

Can a burnt or damaged PCB track be repaired?

Yes, in most cases. Burnt tracks and lifted pads are rebuilt, damaged vias are bridged, and the board is then powered and tested section by section to confirm the repair holds under working conditions.

Do you repair multi-layer boards?

Yes. We work on single-layer, double-layer and multi-layer boards. Internal-layer faults are harder to reach, and if a fault sits where it genuinely cannot be repaired safely, we tell you that clearly at diagnosis.

Should I send the whole equipment or just the board?

Sending just the board is fine if you can remove it safely and note which equipment it came from. If the fault may involve the power supply or connected parts, sending the complete unit gives a more reliable diagnosis.

More questions? See the full repair FAQ or contact the workshop.

WhatsApp Us