Office 17B, Sino Pak Plaza, College Road, Rawalpindi +92 321 2750276 ceo@nztech.com.pk

Industrial & Automation Equipment Repair

Industrial Power & Relay Protection Repair

Repair of industrial power control equipment, protection relays and control gear used in panels and substations.

Book This Repair
Industrial power equipment open on a bench during protection relay and control board repair

What we repair

  • Protection relays
  • Soft starters (control and power sections)
  • Timer and control relays
  • Contactor control circuits
  • Panel power and control boards

Common Faults We See

  • Relay not operating or chattering
  • Protection relay showing a fault or dead display
  • Soft starter tripping or failing to start the motor
  • Control circuit dead after a fault
  • Burnt components inside the panel equipment

How the Repair Is Handled

Protection equipment is safety-critical: we test operation thoroughly after repair and will say clearly at diagnosis if a unit should not go back into service.

  1. Book the job online and note your job number.
  2. Drop the equipment at our Rawalpindi workshop, or courier it to us.
  3. We diagnose the fault and share a quotation — confirmed at diagnosis, with no work done before your approval.
  4. After repair, the equipment is tested and quality-checked before you collect it or we courier it back.

You can follow every stage afterwards on the repair tracking page with your job number and phone number.

Book This Repair

Send in your equipment for diagnosis. The quotation is shared with you before any repair work starts — nothing is repaired without your approval.

Book a Repair Track an Existing Job

Prefer to talk first? Call +92 321 2750276 or message us on WhatsApp.

Industrial Power & Relay Protection Repair — Frequently Asked Questions

Is it safe to repair protection relays?

Protection equipment is safety-critical, so we test operation thoroughly after any repair. If a unit should not go back into service, we say so clearly at diagnosis rather than returning doubtful equipment.

My soft starter trips when starting the motor. Can you find why?

We check the power devices, bypass and control sections, and the signals the starter sees from the motor circuit, then test the start sequence on the bench.

Do you repair control boards inside panels?

Yes. We repair panel power and control boards, timer and control relays, and contactor control circuits — send the board or unit with a note of the fault behaviour.

More questions? See the full repair FAQ or contact the workshop.

WhatsApp Us