Electronics & Component-Level Repair
Battery Charger & BMS Repair
Repair of industrial battery chargers and battery management system boards for lithium and lead-acid packs.
Book This Repair
What we repair
- Industrial and workshop battery chargers
- BMS boards for lithium battery packs
- Charge controller boards
- Protection and balancing circuits
- Charger display and control sections
Common Faults We See
- Charger not starting a charge cycle
- Charging stops early or pack never reaches full
- BMS cutting output under normal load
- One cell group drifting out of balance
- Charger overheating or fan fault
How the Repair Is Handled
We test charge curves and protection behaviour — over-charge, over-discharge, short-circuit and temperature cut-offs — before a charger or BMS board is released.
- Book the job online and note your job number.
- Drop the equipment at our Rawalpindi workshop, or courier it to us.
- We diagnose the fault and share a quotation — confirmed at diagnosis, with no work done before your approval.
- After repair, the equipment is tested and quality-checked before you collect it or we courier it back.
You can follow every stage afterwards on the repair tracking page with your job number and phone number.
Book This Repair
Send in your equipment for diagnosis. The quotation is shared with you before any repair work starts — nothing is repaired without your approval.
Book a Repair Track an Existing JobPrefer to talk first? Call +92 321 2750276 or message us on WhatsApp.
Battery Charger & BMS Repair — Frequently Asked Questions
My charger starts charging then stops early. What is wrong?
Early cut-off can come from the charge-control section, a temperature or current-sensing fault, or the battery itself. We test the charger against a known battery so the faulty side is identified before any repair.
Can a BMS board with one drifting cell group be repaired?
Often yes. We check the balancing and sensing circuits for that cell group and verify protection behaviour — over-charge, over-discharge and short-circuit cut-off — before the board goes back.
Should I send the battery pack with the charger or BMS?
If you can send it safely, yes: testing the charger or BMS with its own pack gives the most reliable result. If not, tell us the pack type and voltage when you book the job.
More questions? See the full repair FAQ or contact the workshop.